BM-500GE / BB-500GE104. Locations and Functions4.1 Locations and functions Lens mount C-mount (Note *1) CCD sensor 2/3 inch CCD sensor 12-pin connector DC +12V power and GPIO interface D-sub 9 pin connector Auxiliary GPIO interface (LVDS IN and TTL IN/OUT) RJ-45 GigE Vision I/F. Accepts connector w thumbscrews. LED GigE Network condition: LINK LED GigE Network condition: ACT Holes for RJ-45 thumbscrews Vertical type (above and below RJ-45). Holes for RJ-45 thumbscrews Horizontal type (left and right of RJ-45) (Note *2) Mounting holes M3 depth 5 mm for tripod mount plate (Note *3)*1) Note: Rear protrusion on C-mount lens must be less than 10.0mm.*2) Note: When an RJ-45 cable with thumbscrews is connected to the camera, please donot excessively tighten screws by using a screw driver. The RJ-45 receptacle onthe camera might be damaged.For security, the strength to tighten screws is less than 0.291 Newton meter(Nm). Tightening by hand is sufficient in order to achieve this.*3) Note: The tripod adapter plate MP-41 can be used with BM/BB-500GEFig. 1. LocationsLINK ACT.DCIN/ TRIGGPIOPOWER/ TRIGGigE① ②③④⑤⑥⑦⑧ ⑨⑩
