GO-5000M-PGE / GO-5000C-PGE- 49 -Sequence ROI H Binning*3 1, 2, 4 (3 is disable) <Set to each Index>Set the H Binning value.Sequence ROI V Binning*3 1, 2, 4 (3 is disable) <Set to each Index>Set the V Binning value.Sequence Repetition 1～255 <For Trigger Sequence Mode>Set the repeat number of the sequence.Command Sequence Index Index 1～10 <For Command Sequence Mode>Set the performed index.Current Sequence Index Index 1～10 only>Refer to the current Sequence Index.Sequence LUT Mode GammaLUTSet the function if Sequence ROI LUT isset to enable.Set the value on Gamma or LUT control.Reset Sequence Index No (EXE command) Reset the Sequence Index to 0.At the same time, the Frame Count isalso initialized.Note 1: If the binning mode is used, the maximum value is changed.Note 2: Only Bayer modelNote 3: Only Monochrome model8.9 Multi ROI modeIn the GO-5000-PGE, the width and height of 5 separate ROIs within the full image area can be set asrequired. Each image can be overlapped. The location of each ROI can also be set as required. The MultiROI data is output as an independent frame.The multi ROI mode is enabled if [Video Sending Mode] is set to “Multi ROI”.Table-27 Multi ROI Index table default valuesFig.33 Multi ROI setting example8.9.1 Multi ROI setting parametersTable-28 Multi ROI commandCommand Parameter DescriptionMulti ROI Index Index 1～5 Select the index to be configured.Multi ROI Width 16～2560 (Note 1) <Set to each Index>Set the width value.Multi ROI Height 1～2048 (Note 1, Note2)2～2048 (Note 3)<Set to each Index>Set the Height value.Multi ROI Offset X 0 ～ 2560(Note 1) - [SequenceROI Width]<Set to each Index>Set the Offset X value.Multi ROI Offset Y 0～2048 (Note 1) - [SequenceROI Height]<Set to each Index>Set the Offset Y value.Multi ROI Index Max 1～5 Set the number of index to beused.Multi ROIIndex SelectorMulti ROIWidth Height OffsetX Y- Index 1 2560 2048 0 0- Index 2 2560 2048 0 0- Index 3 2560 2048 0 0- Index 4 2560 2048 0 0- Index 5 2560 2048 0 0
