JAI SP-12000M-CXP4 User Manual

Contents

JAI SP-12000M-CXP4 User Manual Manual pdf 48 page image

— 48 —SP-12000M-CXP4 / SP-12000C-CXP4Video Process Bypass ModeThe Video Process Bypass mode is a function that bypasses internal image processing on the camera.On the SP-12000, DSNU correction and shading, gain, blemish, and black level adjustment arenormally performed on the sensor output signal. However, when the Video Process Bypass mode isused, images can be imported to the system without image processing* being performed internallyon the camera. The Video Process Bypass mode is ideally used in cases where image processing isperformed by the system.In addition, images are output from the camera in 12-bit format only when the Video Process Bypassfunction is used.* Excluding DSNU correction and black level adjustment.■ Available bit-depth optionsCXP outputSensor output 8-bit 10-bit 12-bit10-bit   12-bit   When bypass is enabled, the sensor output and camera output data can be set to the same bit width.Operating using 12-bit outputs must be performed in bypass mode.CXP outputSensor outputVideo ProcessBypass OffVideo ProcessBypass OnDSNU Correction  Black Adjust Set  Pixel Gain  Shading Correction  Blemish Compensation  Binning  LUT/Gamma  Black SETUP  Test Pattern  Camera output 8/10 bit 8/10/12 bitDifferences in camera operation■ When Video Process Bypass mode is disabledAll video processes are enabled.SensorBlockDSNUCorrectionBlockBlackAdjustBlockShadingCorrectionBlockBlemishCompensateBlockBinningBlockLUT/GammaBlockBlackSetupBlockPixelGainBlock■ When Video Process Bypass mode is enabledAll video processes except DSNU Correction Block, Black Adjust Block, Blemish Compensate Blockand Black Setup Block are disabled.SensorBlockDSNUCorrectionBlockBlackAdjustBlockBlemishCompensateBlockBlackSetupBlock