JBL MS-8 User Manual

Also see for MS-8: User guide Service manual Installing

JBL MS-8 User Manual Manual pdf 17 page image

www.jbl.comiNsTALLATiONInstallation warning and tips• Always wear protective eyewear when using tools.• Before beginning the installation, disconnect the negative (–) lead from the vehicle’s battery.• Check clearances on both sides of a potential mounting surface before you drill any holes or install anyscrews. Remember that the screws can extend behind the surface.• At the installation sites, locate and make a note of any fuel lines, hydraulic brake lines, vacuum lines andelectrical wiring. Use extreme caution when cutting or drilling in and around these areas.• Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep the material fromsnagging in a drill bit.• When routing cables, keep input-signal cables away from power cables and speaker wires.• When making connections, make certain that they are secure and properly insulated.CHOOSING A LOCATION FOR THE MAIN UNITCables and wiring• Before mounting the main unit, plan your system’s wiring to ensure that all the necessarycables and wires will reach the mounting location.• Leave enough room around the unit to accommodate all of the connecting cablesand wiring harnesses.• If you’re planning on permanently mounting the display unit in the vehicle, be sure to mountthe main unit close enough to the display unit’s intended mounting location so the supplied6m (19.7 ft) cable will reach between them.Cooling requirements• Make sure that the mounting location will supply enough air for the unit to cool itself.• Do NOT mount the main unit in the engine compartment.Suitable mounting locations• Under a seat (provided that the unit and connecting cables don’t interfere with the seat-adjustment mechanism).• In the trunk.• In any other location that provides enough cooling air.17