JBL MS-8 User Manual

Also see for MS-8: User guide Service manual Installing

JBL MS-8 User Manual Manual pdf 24 page image

www.jbl.comCALiBrATiON/seTUPDISTRACTION WARNING: DO NOT SET UP YOUR MS-8 WHILE DRIVING. We recommendperforming these setup procedures while parked at home or after pulling off the road intoa position that you are absolutely sure presents no risk. Always obey all traffic laws whiledriving.Before you beginIMPORTANT! The MS-8 will not pass an audio signal through to its outputs untilyou have configured it according to the setup procedure described below.The setup procedure consists of four main parts:Language selection: You will select the language that the MS-8 will use on the display.See , on page 25.Input setup: The MS-8 will use the included setup CD to analyze and condition the inputsignal for further processing. See , on page 25.Output setup: You will configure the crossover settings and identify the output channels.See , on page 26.Acoustic calibration: The MS-8 will automatically equalize the signal sent to theloudspeakers and optimize their response for up to four seating positions using the includedbinaural microphone headset. See , on page 32.You must complete all four of these steps in the above sequence. If you stop the setupprocedure before completing all of the steps, the MS-8 will start at the beginning of the lastcomplete section when you turn it back on. Be sure to have your completed ConfigurationChart (see page 11) handy. It will make configuring the outputs easy.Start the MS-8 by turning on the vehicle radio or head unit (or turning the vehicle’s key tothe ACC position if you’ve connected the Rem In terminal to ACC power).Use the remote control’s Up and Down navigation buttons to highlight items on the display.Press the remote’s Select button to select a highlighted item. Use the remote’s Left andRight navigation buttons to make changes in items on the display.SelectbuttonLeft/RightnavigationbuttonsUp/DownnavigationbuttonsBackbutton24