JCM GLOBAL VEGA 100 Service Training Manual
                        | |
Contents
| 
Part No. 960-000165R_Rev. 1 © 2013, JCM American, Corporation1 1July, 2013 JCM Training Overview VEGA™ Banknote AcceptorLecture NotesFUNCTIONAL TESTINGDIP SWITCH TESTPerform the following steps to test the functionality of each DIP Switch Block:1. Ensure that the VEGA's Power is OFF.2. Set all DIP Switches on DS 1 and DS 2 to the ON position.3. Apply Power to the VEGA.4. Set DS 1, Switch #1 to OFF. The Front Panel LED will go out (Extinguish).5. Set DS 1 Switches #3, #5, & #7 and DS 2 Switches #1, #3, #5, & #7 to OFF.The Front Panel LED will blink at a Yellow Color Rate.6. Set DS1 and DS2 Switches #2, #4, #6, & #8 to OFF. The Front Panel LED willblink at a Blue Color Rate if all the DIP Switches function properly.FEED MOTOR FORWARD ROTATION TESTPerform the following steps to test the normal forward rotation functionality ofthe Feed Motor:1. Ensure the VEGA's Power is OFF.2. Set DS1, Switch #1 ON.3. Apply Power to the VEGA.4. Set DS1, Switch #1 OFF. This begins the Feed Motor Forward Rotation Test.5. If the Feed Motor correctly rotates forward, the Front Panel LED will remainextinguished (Out) and forward rotation will continue.6. To end the Test, Set DS 1 Switch #1 to ON.Table 5 Transport Motor Abnormal Error CodesLED Color Blink Sequence Error IndicationWhite3 Feed Motor Low Speed Problem5 Feed Motor High Speed Problem7 Feed Motor Lock-up ProblemNOTE: If the Front Panel LED blinks any White sequence in Table 5, the FeedMotor Forward Rotation is abnormal. |
manualsdatabase
Your AI-powered manual search engine