JETWAY 915GDAPR1A User Manual
                                              | |
Contents
| 
293-7-3 Onboard Super IO FunctionCMOS Setup Utility – Copyright(C) 1984-2004 Award SoftwareOnboard Super IO FunctionItem HelpOnboard FDD Controller EnabledOnboard Serial Port 1 3F8/IRQ4Onboard Serial Port 2 2F8/IRQ3UART2 Mode Select NormalRxD, TxD Active Hi, LoIR Transmission Delay EnabledIR Duplex Mode HalfIR Pins IRRX/IRTXOnboard Parallel Port 378/IRQ7Parallel Mode SPPEPP Mode Select EPP1.7ECP Mode Use DMA 3Menu Level >>↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General HelpF5:Previous Values F6:Optimized Defaults F7:Standard DefaultsOnboard FDD ControllerSelect Enabled if your system has a floppy disk controller (FDD) installed on the system board andyou wish to use it. If you install add-on FDC or the system has no floppy drive, select Disabled in thisfield. The settings are: Enabled and Disabled.Onboard Serial Port 1/Port 2Select an address and corresponding interrupt for the first and the second serial ports. The settingsare: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.UART2 Mode SelectThis item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this functionsuses.Onboard Parallel PortThere is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP, andEPP features. It has the following option:Disabled(3BCH/IRQ7)/ Line Printer port 0(278H/IRQ5)/ Line Printer port 2(378H/IRQ7) Line Printer port 1Parallel Port ModeSPP : Standard Parallel PortEPP : Enhanced Parallel PortECP : Extended Capability PortSPP/EPP/ECP/ECP+EPPTo operate the onboard parallel port as Standard Parallel Port only, choose “SPP.” To operate theonboard parallel port in the EPP modes simultaneously, choose “EPP.” By choosing “ECP”, theonboard parallel port will operate in ECP mode only. Choosing “ECP+EPP” will allow theonboard parallel port to support both the ECP and EPP modes simultaneously. The ECP modehas to use the DMA channel, so choose the onboard parallel port with the ECP feature. Afterselecting it, the following message will appear: “ECP Mode Use DMA” at this time, the user canchoose between DMA channels 3 to 1. The onboard parallel port is EPP Spec. compliant, soafter the user chooses the onboard parallel port with the EPP function, the following message willbe displayed on the screen: “EPP Mode Select.” At this time either EPP 1.7 spec. or EPP 1.9spec. can be chosen.← (only for 915PDAP/915PDA) |
Related manuals for JETWAY 915GDA
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine