jGun14 JETYD Operations ManualLoosening a Fastener1. Set the FRL Pressure to max PSI as listed on Pressure/Torque Conversion Chart.2. Fully engage the torque wrench socket on the nut.3. Either place the reaction arm firmly against a stationary surface or engage the LoaDiscDriver over the reaction washer.Figure 11. Using the jGun with a Reaction Washer4. Ensure the torque wrench is set to the loosening direction.5. Remove the fastener.jGun Repair and MaintenanceAlthough the FRL Unit keeps the jGun self-maintained by continuously provided pneumatic tooloil to the tool during operation, proper repair and preventative maintenance will ensure the fulllife span of your tool.Maintaining Hoses and Fittings Visually inspect air lines and air line fittings before tool use Replace worn or leaking air lines Tighten leaky fittings
