Jabra PRO 9470 User Manual

Also see for PRO 9460 - 2: Quick start guide Datasheet Datasheet Datasheet

Contents

Jabra PRO 9470 User Manual Manual pdf 15 page image

15 englishJabra PrO 9460, 9460-DuO anD 9470 user manualthe Quick-StaRt SetuP wizaRd4.2to get started, just power the base and then follow the set-up-wizard instructions on the touchscreen.to run the setup wizard:1. review the information outlined in Section 4.1: Setup Overview and Background. It will help you understand thetypes of tasks that the setup wizard will ask you to do.2. assemble the base and apply power to it. (see also Section 4.3: Preparing the base and and Assembling theHeadset).3. the base automatically launches the setup wizard the first time you turn it on. On each page of the wizard,follow the instructions shown and then touch the “next” icon (see also Section 8.2: Using the Touchscreen).- Note: when the wizard is helping you set up your desk phone, it will ask you to call the Jabra test server.this enables the base to test its clear dial-tone switch and mic.-level settings by exchanging signals withthe test server. see your Jabra PrO Quick start guide for a list of Jabra test-server phone numbers (alsoavailable on our web site). If, for some reason, the connection to the test server fails, you are prompted toretry; you can retry the automatic setup or try a manual setup. you can also choose to retry the cable setup.4. Continue until the wizard tells you that you are finished. at this point, all of your phones should be connectedand your headset will be fully configured to work with each of them.the remainder of this chapter provides extra information about each step of the setup process. refer to thischapter if you have trouble while working through the on-screen setup wizard.Tip: you can re-start the setup wizard manually at any time, thereby re-initializing some or all base andheadset settings. see Section 8.9: Re-running the Setup Wizards for details.PRePaRing the BaSe and and aSSeMBling the headSet4.3Adjusting the Headset Cradlethe headset cradle is already attached to the Jabra PrO base when it is delivered but you might want to adjust itsangle in order to optimize for left- or right-handed docking. to do this, simply rotate the cradle until it sits at yourpreferred docking angle. as you rotate the cradle, you will feel it fit into a number of distinct positions on thebase. the figure below shows the angular range; -90 to +45 degrees.-9045Figure 8: Adjusting the headset cradle angle on the baseIf, at a later stage, you need to remove the cradle (for example to replace it with another), simply rotate the cradleclockwise as far as possible, then carefully pull it out from the base.to attach / re-attach a headset cradle on the base, hold the cradle against the base so that the large and smallpins on either side of the cradle post align with the matching slots on either side of the hole on the base. thensimply push it into the base.