Jabra SP500 User Manual

Also see for SP500 - Bluetooth hands-free Speakerphone: Specifications User manual User manual User manual

Contents

Jabra SP500 User Manual Manual pdf 5 page image

Using voice-dialling (if supported by your phone)1. Press and release once. You’ll hear one short beep while doing this.2. You’ll then hear the voice-activation tone; say the name of the person you wish to call.NOTE: Record voice tag via your mobile phone. If you have a Nokia phone you will beable to record the voice tags via your Speakerphone.5EnglishUsing your mobile phone’s keypad1. Dial number on keypad.2. Press phone’s “send” key.3. The Jabra SP500 has automatic volume control and will automatically adjust thespeaker volume based on the relevant back ground noise. In order to adjust thevolume according to your own preferences, use the volume control wheel.Making a call5• Press and release onceOR• End call from your mobile phone’s keypadEnding a call64English• To enable mute press the mute button for one second and you will hear a shortbeep. You’ll see solid yellow light.To disable mute function press the mute button briefly.Muting a call8Answering a call7• After you hear the ring tone, press and release once.OR• Answer the call with your mobile phone’s keypad. You may then need to transfer the callto the speakerphone by pressing and releasing once (depending on your phone).1. Ensure SP500 is switched on. (See section 3)2. Press the Pairing button until you see a solid blue light (approximately 2 seconds),then release. Your Speaker phone is now in pairing mode.3. Set your Bluetooth phone to “discover” the speakerphone by following yourphone’s instruction guide. Typically, the steps involve going to a “setup”, “connect”,or “Bluetooth” menu on your phone and then selecting the option to “discover” aBluetooth device*. (See example from a typical mobile phone in fig. 3)4. Your phone should find the “Jabra SP500” speakerphone and ask if you want to pairwith it. Confirm by pressing “yes” or “ok”.5. Enter passkey or PIN³ = 0000 (4 zeros), then press “yes” or “ok”IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidlybefore going back to flashing blue every 3 seconds. You will also hear the confirmationmelody. If unsuccessful, the light remains solid, and you’ll need to re-attempt pairing.(See steps 3–5 above)“Pair”² with your Bluetooth mobile phone4USING YOUR JABRA SP500Before using your Jabra SP500, ensure that the batteries are charged and the Jabra SP500is paired (see item 3) with your Bluetooth mobile phone and switched on.The speakerphone can be used while being recharged from a wall socket or from the carcharger. • It is recommended that you use your mobile phone’s keypad which typicallyinvolves pressing the “send” button.OR• Press and hold until you hear two beeps to answer the incoming call and switchbetween calls (some phones do not support call-waiting via this method).* See Enhanced features section for alternative call-waiting instructions formobile phones that support the hands-free profile. See Section 13 for furtherdetails about Bluetooth profiles.Call-waiting*9To avoid the Jabra SP500’s LED lights from distracting you when driving at night the LEDlights will be switched off 1 min after an active call. It is also possible to prevent the LEDfrom flashing by pressing and holding the mute button for 10 seconds until you hear asecond beep. The Jabra SP500 will still function during this time. When you switch offthe unit and then switch it back on again the LED lights will commence flashing again.Indicator light10