Jacuzzi BZ00000 Installation And Operating Instructions Manual

Contents

Jacuzzi BZ00000 Installation And Operating Instructions Manual Manual pdf 19 page image

TOWERS AND DOOR INSTALLATIONSTEP 26Seal all around all bases of towers with sealant. Also seal the inside of wall posts, jambs, door posts, tile joint to wallpost, and bottom of glass side panel on the inside only.CLEAN UP AFTER TOWERS AND DOOR INSTALLATIONTo avoid dulling and scratching the tower surfaces and support rails never use abrasive cleaners. Use a mild liquiddetergent and warm water clean soiled surfaces. Use a mild glass cleaner to clean glass panels and doors.Paint, tar, or other difficult stains can be removed with normal glass and finish cleaners. Use caution when applyingthese products to coated metal surfaces. Test in an inconspicuous place before using. Do not use abrasives,alcohol, acetone, ammonia or other solvents on any tower component.Scratches to towers and metal components may not buff or polish out requiring surface refinishing or replacement.Consult your Jacuzzi Whirlpool Bath © dealer or visit our website at: http://jacuzzi.com/ for a list of authorized finishcontractors.17Jacuzzi Whirlpool Bath © BZ00000 03/05STEP 27Remove tape over drain and any other masking or protective covers. Proceed with clean up.APPLY SEALANT ALONG BASE ANDSIDE OF WALL POST AND GLASS ANDWALL POST (2 WALL ONLY)APPLY SEALANTALONG BASEOF FIXED GLASSAPPLY SEALANT ALONG SIDE OF JAMBAND DOOR POST AND JAMB AND GLASS(BOTH TOWERS)APPLY SEALANT ALL AROUNDTOWER BASES (ALL 3 BASES)(RAIL NOT SHOWN)APPLY SEALANT ALONG SIDEOF TILE JOINT TO WALL POST(2 WALL ONLY)(2 WALL AND 3 WALL)(2 WALL AND 3 WALL)