Jacuzzi J - 2 0 Owner's Manual

Also see for J - 210: Owner's manual Owner's manual Owner's manual Owner's manual Installation manual and user's guide

Contents

Jacuzzi J - 2 0 Owner's Manual Manual pdf 45 page image

J-200 SeriesVerify water level is 1" below lowest pillow. Add water if necessary.1.Check for clogged or dirty filter cartridge (sec. 12.1, page2. 32).Purge “air lock” from circulation pump intake by removing filter3.cartridge. Hold your garden hose over the filter cartridge wall fittingwhile using a rag as a seal around hose end. Ask a helper to turnon water for 30 seconds, then turn off. Reinstall filter cartridge andcheck spa (sec. 12.1, page 32).If the circulation pump is not running, turn power off at the main4.breaker, then turn power back on. This will reset the circulation pumppriming cycle. Once the pump is primed, the error should clear.If problem persists, contact your authorized Jacuzzi dealer.5.14.8 panel Displays oHwarnInG: rIsk oF HYperTHermIa (over-HeaTInG)Causing severe inJury, burns, or welts.!Water temperature is above acceptable limits. Do noTenTer spa! Water temperature has reached 112˚F(44˚C) and the low speed jets pump 1 and optionalcirculation pump (when equipped) has activated to circulate waterthrough heater. Contact your authorized Jacuzzi dealer or qualifiedservice technician.14.9 panel Displays (- - -)warnInG: rIsk oF HYperTHermIa (over-HeaTInG)Causing severe inJury, burns, or welts.!Water temperature is above acceptable limits. Do noTenTer spa! The safety “Watchdog” software has beentriggered and the spa is deactivated. A problem has beendetected which could cause damage to the spa or itscomponents. Contact your authorized Jacuzzi dealer or qualified servicetechnician.41