J-200lock modes (l1-l2)l1 Lock Out (disables all spa functions to permit filtercleaning)l2 Lock Mode (disables the jets and light buttons toprevent unauthorized use of spa). Filtration/heatingcycle will continue to operate as programmed inthis mode. The temperature display flashes when this function isenabled. Example: the “F3” filtration/heating cycle was enabledprior to choosing lock mode. The spa continues to perform the“F3” cycle until lock mode is canceled, allowing another cycle to beselected.To set a time for the first filtration/heating cycle, simply turn power on tothe spa two minutes prior to the desired time. Example: If you desire yourfirst filtration/heating cycle to begin at 10:00 AM turn off power to the spaand turn it back on again at 9:58 AM.note: Start time is approximate and may vary slightly from day to day.11.7 Filtration modes for spas with Circulation pump option(J-230, J-270 and J-280 only)If your spa is not equipped with the circulation pump option, disregardthis section and refer to page 29 for filter cycle programming details.standard Filtration/heating Modes (F0-F3)(Heater automatically turns on during any heat call while in any Standardmode).F0 5 minutes of filtration per day (one 5 minute “Blow-Out”cycle every 24 hours to purge all plumbing lines)F1 1 hour of filtration per day (one 30-minute cycle everytwelve hours); this is the factory default setting.F2 1.5 hours of filtration per day (one 30-minute cycleevery eight hours).F3 2 hours of filtration per day (one 30-minute cycle everysix hours).economy Filtration/heating Modes (F4-F6)(Heater can only turn on during an active filter cycle while in anyeconomy mode).F4 1 hour of filtration/heating per day (one 30-minutecycle every twelve hours).F5 1.5 hours of filtration/heating per day (one 30-minutecycle every eight hours).F6 2 hours of filtration/heating per day (one 30-minutecycle every six hours).30