J-20012.0 spa maintenanceProper and regular maintenance of your spa will help it retain its beautyand performance. Your authorized Jacuzzi dealer can supply you withall the information, supplies, and accessory products you will need toaccomplish this.DanGer: rIsK oF severe InJurY or DrownInG BYenTrapmenT!Keep hair, loose articles of clothing or hanging jewelry away from•suction fittings, rotating jets or other moving components to avoidentrapment that could lead to drowning or severe injury.Never use the spa unless all suction guards, filter, filter lid, or skimmer•assembly are installed to prevent body and/or hair entrapment.Never operate or use the spa if the filter, filter lid, or skimmer assembly•are broken or any part of the skimmer assembly is missing. Pleasecontact your dealer or nearest service center for service.The suction fittings and suction covers in this spa are sized to match•the specific water flow created by the pump(s). If it is necessary toreplace the suction fittings, suction covers or pump(s), be sure that theflow rates are compatible and are in compliance with the VGB SafetyAct page 2.Never replace a suction fitting or suction cover with one rated less•than the flow rate marked on the original suction fitting. Using impropersuction fittings or suction covers can create a body or hair suctionentrapment hazard that may lead to drowning or severe injury.Owners must alert all spa users to the potential risk of Hair, Limb,•Body, Evisceration (disembowelment), and Mechanical Entrapment,page 6.!12.1 Cleaning The Filtersto DeCrease Drowning or entraPMent, always turnpower To spa oFF BeFore CleanInG THe FIlTer CarTrIDGe!J-210 models:These model spas are equipped with a skimmer basket and filtercartridge located in the skimmer/filter well. Filtering is accomplishedwhen jets pump #1 turns on in low speed initiating water flow throughthe skimmer basket and polyester mesh filter cartridge. As this happens,suspended particles become trapped on the filter’s surface.To Clean Filter:1. Turn off power to the spa at the home’s breaker panel or select the L1“Lock Out” mode (page 29) to disable all spa functions.2. Remove the filter strainer lid assembly.3. Remove the filter cartridge by rotating it counterclockwise to unthread itfrom the filter wall fitting, then lift it straight up to remove from filter well.4. Using a garden hose with a high-pressure nozzle, rinse debris fromthe filter pleats beginning at the top and working your way downward.Continue, one section at a time, until you have rinsed all of the filter’spleats.32