Page 46J-400 Series5. Pull the larger (rear) body outward as shownto open drain.6. After the spa drains, perform steps 2-5 inreverse order to close the drain prior to refilling spa.After refilling, turn on power to the spa and follow the steps listed under“Spa Fill Up Procedures.” (page 15). Always fill your spa through bothfilter buckets.13.3 Cleaning the spa InteriorTo preserve the sheen of your spa’s surface, it is crucial that you avoidusing abrasive cleaners or cleaners which have adverse chemical effecton the surface. If you are not certain as to the suitability of a particularcleanser, consult your authorized Jacuzzi dealer. Regardless of thecleanser used, use extreme care to assure that no soap residue is left onthe surface. This could cause severe sudsing when the spa is refilled.13.4 Pillow CareClean the four headrests in your spa as needed by wiping them with acloth with soapy water. It is not necessary to remove the headrests forcleaning.To remove headrests for long term storage or replacement, grasp bothends of each headrest and gently pull inward towards the center of thespa. To reinstall, over mounting strip and press down until headrestmounting bracket emits a “click” sound. Then adjust headrest height bysimply moving up or down as desired.13.5 maintaining the synthetic CabinetThe synthetic cabinet requires little or no maintenance of any kind. Toclean, simply wipe cabinet with mild detergent soap solution and a cleantowel.CauTIOn: Never spray cabinet with a high pressure gardenhose for any reason since this action may induce an electricalshort in the spa’s electrical equipment.13.6 maintaining the CoverUsing the Jacuzzi insulating spa cover anytime the spa is not in use willsignificantly reduce your operating costs, heat-up time, and maintenancerequirements. To prolong the life of the cover, handle it with care andclean it regularly using mild soap and water. Periodic treatments with aspecial conditioner developed for Jacuzzi spa covers will help protectOpen Drain5.