Page 60J-40013.2 auto-Heating modeAuto-Heating mode is typically selectedby customers in cold climates where heatup times are extended due to lowerambient temperatures. In this mode,water temperature is regulated by the settemperature which activates the heaterautomatically as needed.note: If you elect to use Auto-Heating, you can skip thissection. Auto-Heating is the default spa setting.1. Press button B to enter the HeatingMenu (Figure C). The menu appearswith Auto-Heating selected. If youelect to use this mode, press theSplash button on the Quad Keypad.The display will confirm yourselection and Figure D will bedisplayed.2. To exit the submenu, press button D to return to the “Settings 2”Menu.13.3 Programmable Heating modeProgrammable heating mode is typically selected by customers in warmclimates where heat up times are minimized due to higher ambienttemperatures. In this mode, the water temperature is regulated by the settemperature only when a programmed heating cycle is running, unless insummer logic page 64.1. From the Heating Menu (Figure C), use the Quad Keypad Downbutton to select the programmable setting, then press the Splashbutton to enable selection.A. Program a Heating mode1. You are allowed to have two separateprograms in the programmablemode, you can elect to use both orjust one. Press the Splash button toenter the submenus for “Program A”(Figure E).HEATINGAuto-HeatingPress to setSelectAProgrammableAuto-HeatingFigure C24-hour HeatingEnabledFigure DFigure EPROGRAMMABLEProgram APress to setSelectBProgram BAProgram A A
