Jacuzzi SALON SPA BATH SERIES Installation And Operation Instructions Manual

Contents

Salon™ Spa BathPage 8 www.jacuzzi.com Installation and OperationEnglishClearance Examples2-Wall Installation3-Wall Installation• To ensure the installer has space to maneuver and install the bathtub, allow adequate wall and ceilingclearance (Figure 3).32˝(812mm)3˝(76mm)10˝(254mm)32˝(812mm) 48˝(1219mm)32˝(812mm)32˝(812mm)3˝(76mm)32˝(812mm)10˝(254mm) 10˝(254mm)Floor Cutout forDrain/OverflowFloor Cutout forDrain/Overflow Floor Cutout forDrain/OverflowFloor Cutout forDrain/OverflowBATHTUBCUTOUTBATHTUBCUTOUT BATHTUBCUTOUTBATHTUBCUTOUTFraming (con’t)SubfloorPrepare the subfloor for the drain and ensure that the area is level.1 The drain/overflow of the bathtub extends below the bottom of the bathtub. Identify the drawing in the TechnicalSpecifications Manual that corresponds with your bathtub.2 Make appropriate cuts to the subfloor to accommodate the drain.3 Jacuzzi’s Tru-Level™ base is a standard feature on all bathtubs. If the subfloor is level and a continuous surface,no other preparation is necessary. Proceed to the “Installation” section.4 If the subfloor is not level, you must level the entire surface prior to installing the bathtub. The materials usedwill insure that the bathtub is supported from the bottom. These materials include: leveling compound, mortar,plaster or minimal expansion structural foam (having a density of a minimum 5lbs/cubic foot). The bathtub mustremain level in order for it to drain properly and must make contact with the leveling material. Both sides of a jointor splice of subfloor should be level to each other.Figure 348˝(1219mm)