14SHORT PANELLONG SIDE PANELDOOR PANELPHILLIPS HEAD SCREWS (6)FACTORY INSTALLED REDWOOD SKIRTMAINTENANCEFactory Installed Redwood SkirtYour spa is supplied with a factory-installed redwoodskirt which completely surrounds the spa. The door can beopened for routine maintenance.CAUTION: Do not attempt to lift the redwood skirt doorpanel higher than the top of the spa. Doing so may causedamage to the skirt door.The skirt is made of kiln-dried redwood and can be leftnatural to weather or you may choose to apply a stain orclear finish. Consult your local paint dealer for the appropri-ate product. Do not use oil-based stains or sealers.It may become necessary to remove one or more of theskirt panels for major service access, but all the panelsmust be securely in place during use of the spa.To detach any of the panels or the short door rear panelon the opposite side of the spa, remove all screws from thepanel being detached. Then pull the bottom of the paneldownward and outward from the bottom of the panel.To detach either of the long side panels, it is firstnecessary to remove one short panel (door or rear). Re-move the screws from the panel; then slide the panelhorizontally and pull downward. The panels can be reat-tached to the spa by reversing this procedure.Cleaning Your SpaYour spa shell consists of two layers of plastic materi-als. Its smooth top surface of acrylic is tough and durableand contains concentrated color. This is supported by asubstantial thickness of fiberglass-reinforced polyesterresin. A catalyst causes a chemical reaction during manu-facture that bonds these layers permanently into a hard,strong material. With a minimum amount of care andcleaning, your whirlpool spa will look new for years.To clean your spa, simply use a mild, nonabrasiveliquid detergent, or commercially prepared spa cleaner.Do not use abrasive cleaners. You can protect andrestore the gloss to a dulled surface by applying Meguiar’s#10 Mirror Glaze, which is a product specifically designedfor use on acrylic finishes. If Meguiar’s is not available, anacrylic polish of equal quality or automotive paste wax willdo.Use a spa cleaner for residue buildup at the water levelof the spa surface. This may be applied to the acrylicsurface with a soft cloth and wiped clean. Use sparingly insmall amounts to avoid contaminating the spa water. Ifheavily soiled, it may be advisable to lower the water level2–3 inches before cleaning, then refill to normal level.Repairs to the AcrylicMinor scratches which do not penetrate the color finish(acrylic) can be removed with 600-grit wet/dry sandpaper.Restore the glossy finish with Meguiar’s #10 Mirror Glaze.If that is not available, use automotive rubbing compoundfollowed by an application of automotive paste wax.Major scratches or gouges which penetrate the acrylicsurface will require refinishing. Ask your spa dealer forspecial instructions.