3SPA CONTAINED IN SHIPPINGCARTON, SECURED BY BANDSSKIRT BASESPA RIMPADDED CARTOR DOLLYSURFACE MUST SUPPORTSPA RIM AND BASE SKIRTINSTALLATIONCheck for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spasustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on the outsideof the carton and immediately file a claim with the carrier.Once the spa has been removed from the carton and before it is permanently installed (see below on this page forunpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system (seeOperating Instructions) to check for leaks that may have resulted from shipping or handling. All Jacuzzi Whirlpool Bath spasare factory tested for proper operation and water tight connections prior to shipping. If leaks or other problems are detected,immediately notify your dealer or Authorized Service Agent, or call 1-510-938-7411 for Warranty Service.Note: Damage or defects which could have been discovered and repaired prior to installation and which areclaimed after final installation of the spa are excluded from our warranty.Inspection and Shipping ClaimsUnpacking1. Remove the outer carton by cutting the bands andlifting the cover and the sides.2. Remove the spa cover which is located on top of thespa. Leave the protective plastic sheet on the spa untilinstallation begins. This sheet can be reused to protectthe finish from damage and debris during construction.3. Lift the spa from the carton (approximate weight 350lbs.) and set it in place on the patio, deck, or position ofintended use.4. If, after having been removed from the carton, the spamust be turned onto its side to move it, make sure thesurface of the cart or dolly on which it is placed is largeenough to support the entire width of the spa, includingthe rim and base of the skirt. The skirt is not designedto support the product weight and could be damaged ifallowed to do so. For further protection of the skirt,make sure the surface of the cart or dolly is padded. Donot allow the spa to rest on the equipment door side.See illustration at lower right.5. Before installation begins, remove the owner's packetfrom the accessory package. This package containsthe Warranty Card and the Owner's Manual. Recordthe spa serial number on the inside front cover of thismanual and on the warranty card. (See illustration onpage 2 for location of the serial number.)6. Place the filter cartridge in a dry place for later use.Important: Read all instructions in the Owner’s Manualbefore beginning installation.