James Rebarscope R-C-400 Operator's Manual
                                                                            | |
Contents
| 
11www.ndtJames.comShort / Deep ModeThe Rebarscope® facilitates the analysis of rebar location, coverand bar sizing; allowing the user to do measurements in short modeor deep mode. The Rebarscope® also provides the user the abilityto automatically switch between deep and/or short mode.Note: The single sensing probe operates efficiently in both modes.When the system is initially turned “on”, the Automatic (RS) mode isthe default setting. To change this, go to the Locate Cover screen.• Once in the Locate Cover screen, use the up or down arrow keyson the front panel to highlight the graphic bar .• When the highlight is on the bar, press the left arrow key tochange between modes. (Note: The letters RS in the upper lefthand corner of the screen indicate auto ranging is “on”.)• Follow the procedure above to turn off Auto ranging, and tomanually switch between Deep and Short modes as seen on line 1of this screen.Figure 5: Locate Cover Screen |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine