Janam XG3 User Manual

Also see for XG3 Series: Quick start guide User manual

Contents

Janam XG3 User Manual Manual pdf 8 page image

Getting Started XG3 User ManualJanam Technologies LLC 2―2Install the BatteryThe XG3 mobile computer is shipped with the battery packaged separate from the unit. Follow the stepsbelow to install the battery.1. Remove the battery compartment door by moving the battery door’s metal locks to the upposition. With the locks in the up position, pull door away from device housing.Insert the battery with the batteries flat surface facing down.2. Replace the battery door by inserting battery door tabs into guides near the handle, then pressdown on the battery door locks.☞NOTE: The battery door must be installed in order to power the device on.WARNING: Use only Janam approved Li - Ion battery packs. Unauthorized batteries may result indamage not covered by the warranty.Changing the Main Battery PackBefore removing a battery pack, press the Power key to put the terminal in Suspend Mode so thatoperations are suspended before removing the main power source. Always put the terminal in SuspendMode prior to changing the battery.☞NOTE: The battery door must be installed prior to booting the unit.Charge the BatteriesThe XG3 ships with only the main battery pack significantly charged. Charge the main battery pack withthe XG3 charging cable for a minimum of 4 or 6 hours before initial use.Charging with DC Adaptora. Attach the appropriate plug adapter to the plug of the power cable.b. Insert the plug into the appropriate power source. Plug the XG3 power cable intothe DC Jack at the bottom of the unit.