Jandy Pro Series Installation And Operation Manual
Also see for Jandy Pro Series: ManualInstallation and operation manualOwner's manualInstallation manualInstallation and operation manual
                                                | |
Contents | 
Page 9ENGLISHJandy® Pro Series, White LED Lights | Installation ManualClockMotorGroundGroundNeutralLineA 1 2GFCIBlackWhiteGreenBlackWhiteGreenJUNCTIONBOX120VLEDLight120 VSUPPLYFigure 4. Wiring the Jandy Pro Series White LEDLight to a Time ClockGroundGroundNeutralLine120 VSupplyGFCIBlackWhiteGreenJUNCTIONBOXBlackWhiteSWITCHBlackWhiteGreen120VLEDLightFigure 5. Wiring the Jandy Pro Series White LEDLight to a SwitchSection 7. Replacing LED Boardand Driver (PCB)WARNINGAlways disconnect power to the light at the circuitbreaker before servicing the light. Failure to do socould result in death or serious injury to installer,serviceman, pool or spa users or others due toelectrical shock.1. Turn off the main electrical switch or circuitbreaker, as well as the switch, which operates theunderwater light.2. Be sure to have the following items:• A new lens gasket.• A light driver board. See Table 2 for specification.WARNINGReplace light driver with the same type. Failure toreplace the light driver with the same type will damagethe light assembly and may cause an electrical hazardresulting in death or serious injury to pool or spa users,installers, or others due to electrical shock, and mayalso cause damage to property. Be sure the power isswitched OFF before removing or installing PCB. AllowPCB to cool before replacing.3. To remove the light assembly, unscrew the specialpilot screw at the top of the face ring, removelight assembly from niche and gently placeassembly on the deck. It is not necessary to draindown the pool. See Figure 6.Table 2. Light SpecificationsJandy ProSeries ModelFixtureVoltageWatts Light Driver (PCB)Part NumberWhite LEDLarge Light 12 VAC 65W R0802600White LEDLarge Light 120 VAC 65W R0802700White LEDLarge Light 12 VAC 42W R0802800White LEDLarge Light 120 VAC 42W R0802900White LEDSmall Light 120 VAC R0803200White LEDSmall Light 12 VAC R0803300WARNINGBe sure to keep the special pilot screw from thisunderwater light. This screw mounts and electricallygrounds the housing securely to the mounting ringand wet niche. Failure to use the screw provided couldcreate an electrical hazard, which could result in deathor serious injury to pool or spa users, installers orothers due to electrical shock.7.1 Pool Clamp Removal.1. Loosen the Phillips head screws (six (6) for smalllight, eight (8) for large light) to allow the bottomclamp to be removed from the face ring assembly.Do not remove the screws or the retaining rings.The retaining rings prevent the screws fromfalling free from the bottom clamp and also aid inease of assembly. |
Related manuals for Jandy Jandy Pro Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine