Page 4Section 1. Important Safety InstructionsREAD AND FOLLOW ALL INSTRUCTIONS1.1 Safety InstructionsAll electrical work must be performed by a licensed electrician and conform to all national, state, and localcodes. When installing and using this electrical equipment, basic safety precautions should always be followed,including the following:WARNINGTo reduce the risk of injury, do not permit children to use this product.WARNINGRISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUSINJURY OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use thispump for wading or shallow pools or spas containing bottom drains, unless the pump is connected to atleast two functioning suction outlets. Drain covers must be certified to ANSI/ASME A112.19.8.WARNINGTo reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide,or full flow) valve position with the pump running.WARNINGThe Jandy ® Pumps are powered by a high voltage electric motor and must be installed by a licensed orcertified electrician or a qualified swimming pool service technician.WARNINGDue to the potential risk of fire, electric shock, or injuries to persons, Jandy ® Pumps must be installed inaccordance with the National Electric Code, all local electrical and safety codes, and the OccupationalSafety and Health Act (OSHA). Copies of the National Electrical Code may be ordered from the National FireProtection Association, 470 Atlantic Ave., Boston, MA 02210, or contact your local government inspectionagency.WARNINGIncorrectly installed equipment may fail, causing severe injury or property damage.WARNING• Do not connect system to an unregulated city water system or other external source of pressurized waterproducing pressures greater than 35 PSI.• Trapped air in system can cause the filter lid to be blown off which can result in death, serious personalinjury, or property damage. Be sure all air is out of system before operating.