NOTEIt is normal for the skewer to flex when larger cutsof meat are being cooked.If the meat scrapes on the cooking grids during anypart of the rotation, the cooking grids must beremoved.Adjust the counter balance weight to balance theheavier side of the meat and avoid lopsided rotationof the rotisserie motor.CAUTIONWhen using the rotisserie burner, remove thewarming rack. High heat from the burner may causethe warming rack to bend.BEFORE LIGHTING…Inspect the gas supply hose prior to turning the gas“ON”. If there is evidence of cuts, wear, or abrasion,it must be replaced prior to use.WARNINGDo not use the grill if the odor of gas is present.Contact customer service at 1-800-554-5799.Leak check the piping and regulator connectionswith a soap and water solution before operating thegrill (see Leak testing instruction page 8).Only the pressure regulator supplied with the unitshould be used. Never substitute regulators that arenot supplied with the grill. If a replacement isnecessary, contact the factory for properreplacement.TO LIGHT THE GRILL BURNER1. Make sure all the knobs are in the “OFF”position, and then turn on the gas supply.2. The igniter is built into the valve. To ignite eachburner, simply press and turn the control knobsto the “HI” setting. The valve will click as itsends a spark to the pilot flame.3. If the burner does not light, turn off the gassupply, wait 5 minutes for any excess gas todissipate and then try again.Burner flames should be blue and stable with noyellow tips, excessive noise or lifting.LIGHTING INSTRUCTIONSYellow flames indicate insufficient air. Noisy flamesor flames that lift away from the burner indicate toomuch air (See the “GAS FLOW CHECK” section onpage 8).MATCH LIGHTINGIf the burner does light after several attempts, it canbe lit with a match.1. Wait 5 minutes for any accumulated gas todissipate.2. Insert a lit extended match or lighter through thecooking grids to the burner.3. Press and turn the control knob left to the “HI”setting. Continue pressing the knob until theburner ignites.4. If the burner does not light within 4 seconds,turn the knob off. Wait 5 minutes and try again.TO LIGHT THE ROTISSERIE BURNER:1. Open the lid, and press the knob for about 5seconds without turning it. This will allow timefor gas to flow into the rear burner.2. Turn the knob to the “HI” setting. While turningthe knob, press the igniter button to light therotisserie burner.3. If the burner does not light, turn the controlknob to the “OFF” position.4. If the igniter does not function, follow theinstructions above for match lighting.Keep a spray bottle of soapy water near thegas supply valve and check the connectionsbefore each use.FLAME CHARACTERISTICSCheck for proper burner flame characteristics.Each burner is adjusted prior to shipment.However, variations in the local gas supplymay make minor adjustments necessary.11