Jenn-Air 740-0712 Installation Instructions And Use & Care Manual

Also see for 740-0712: Installation Instructions and Use & Care Guide

Contents

Jenn-Air 740-0712 Installation Instructions And Use & Care Manual Manual pdf 10 page image

10INSTALLATION INSTRUCTIONSUnpack GrillUnpack Grill1. Remove all packaging materials and remove grill from theshipping base.2. Move grill close to desired outdoor location.3. Open the grill hood.4. Using an utility knife to cut yellow straps and packing tape toopen box from top and remove the boxes.5. Remove the warming shelf and grill grates from inside the grilland remove the package inside the firebox.6. Remove foam block and wrap from inside the grill.7. Replace the grill grates.8. Place warming shelf on brackets as shown.9. Dispose of/recycle all packaging material.Install 20 lb LP Gas Fuel Tank TrayThe tank tray should be secured to a fixed location that can beeasily accessed and will allow the gas pressure regulator/hoseassembly to connect to the 20 lb LP gas fuel tank without kinkingor putting strain on the gas pressure regulator/hose assembly.1. Place the tank tray in a location that can be secured using4 screws (supplied) through the predrilled holes.2. Use 4 screws to secure the tank tray. The typical location fora 20 lb LP gas fuel tank is within the enclosure where the tankban be turned on and off easily.Install GrillPlace grill into outdoor enclosure, but leave enough room in theback to connect to the gas supply.LP Gas Installation1. Check that the LP gas pressure regulator/hose assembly ispositioned under the grill (as shown in the followingillustration) and is not pinched or kinked.2. Use 4 screws and the 2-piece 90° brass clamp mountingbracket provided to attach the 90° brass connector to theback of the enclosure. The brass connector is locatedbetween the flexible gas hose and the LP gas pressure/hoseassembly.A. Warming shelf bracketsB. Warming shelfExcessive Weight HazardUse two or more people to move and install grill.WARNINGFailure to do so can result in back or other injury.AB AA. Four ⁵⁄₃₂" x 10 mm truss head screwsA. 4 screwsB. 2 piece 90° brass clamp mounting bracketABA