Jenn-Air 740-0712 Installation Instructions And Use & Care Manual

Also see for 740-0712: Installation Instructions and Use & Care Guide

Contents

Jenn-Air 740-0712 Installation Instructions And Use & Care Manual Manual pdf 7 page image

7Cabinet Cutout DimensionsThe illustration below includes cutout dimensions and minimum spacing requirements. The illustration is for reference. The design ofyour cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed.Center or support surfaces must be level.The installation of this grill must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code,ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.Copies of the standards listed may be obtained from:CSA International8501 East Pleasant Valley Rd.Cleveland, Ohio 44131-5575NOTE: The grill drops into the opening and is supported by its side flanges. Do not use a bottom support.Built-in Outdoor Grill Enclosure Ventilation RequirementsAny enclosure is to be ventilated by openings at both the top andlower levels of the enclosure. The following information is theminimum for proper ventilation of your island construction.■ There should be a minimum of 1⁷⁄₈" (4.4 cm) of clearance fromthe bottom of the grease tray and the front wall of the islandfor proper ventilation.NOTE: There should be no solid surface underneath thefirebox portion of the grill.■ A minimum of 3" (7.6 cm) is required between the back of thegrill and any noncombustible materials. A minimum of24" (61.0 cm) is required between the back of the grill and anycombustible material.■ The island must be vented in one of the 2 following ways:A 90° or a 180° ventilation in the island to ensure that air flowsthrough the island at either 90° or 180°.■ Any enclosure for built-in installation is to have at least oneventilation opening on an exposed exterior side locatedwithin 2½" (6.0 cm) of the top and is to be a minimum of20 in. 2 (129.0 cm 2). One ventilation opening within1½" (3.0 cm) of the bottom of the enclosure, and the bottomopening is to be a minimum of 10 in.2 (64.5 cm 2 ). All ventopenings are to be unobstructed. Every opening is to be aminimum of ¹⁄₈" (0.32 cm) wide.11⁷⁄₁₆" (29.0 cm)3" (7.6 cm)37" (94.0 cm)12" 30.5 cm)1" (2.5 cm)12" 30.5 cm)5" (12.7 cm)10" (25.4 cm)1½" (3.8 cm)5" (12.7 cm)24" (61.0 cm)12" (30.5 cm)23⁵⁄₈" (60.0 cm)21" (53.3 cm)2" (5.1 cm)6" (15.2 cm)8⁵⁄₈" (21.9 cm)3³⁄₈" (85.7 cm)2" (5.1 cm)1" (2.5 cm)1²⁵⁄₃₂" (4.5 cm)1¾" (4.4 cm)22¹⁄₈" (56.2 cm)14" (35.6 cm)7" (17.8 cm)