Jenn-Air 8113P714-60 Use & Care Manual

8Leveling LegsANTI-TIP BRACKETLEVELING LEGBe sure the anti-tip bracket secures one of the rearleveling legs to the floor. This bracket prevents the rangefrom accidentally tipping.Be sure the range is leveled when installed. Ifthe range is not level, turn the leveling legs,located at each corner of the range, until rangeis level.ANTI-TIP BRACKETLEVELING LEGCAUTIONMAINTENANCECAUTIONOven DoorNEVER place excessive weight on or stand on an openoven door. This could cause the range to tip over, breakthe door, or injure the user.• NEVER attempt to open or close door or operate oven untildoor is properly replaced.• NEVER place fingers between hinge and front oven frame.Hinge arms are spring mounted. If accidentally hit, thehinge will slam shut against oven frame and could injureyour fingers.Important: The oven door on a new range may feel “spongy”when it is closed. This is normal and will decrease with use.Oven WindowTo protect the oven door window:1. Do not use abrasive cleaning agents such as steel woolscouring pads or powdered cleansers as they may scratchthe glass.2. Do not hit the glass with pots, pans, furniture, toys, orother objects.3. Do not close the oven door until the oven racks are inplace.Scratching, hitting, jarring or stressing the glass may weakenits structure causing an increased risk of breakage at a laterdate.Storage Drawer (select models)The storage drawer can be removed to allow you to cleanunder the range.To remove:1. Empty drawer and pull out to the first stop position.2. Lift up the front of the drawer.3. Pull out to the second stop position.4. Grasp sides and lift drawer up and out.To replace:1. Fit the ends of the drawer glides into the rails in the range.2. Lift up the front of the drawer and gently push in to thefirst stop position.3. Lift drawer up again and push until drawer is closed.CAUTIONDo not store plastic, paper products, food or flammablematerials in this drawer. The drawer may become too warmfor these items when the oven is in use.To Replace Oven Light Bulb:1. When oven is cool, hold bulb cover in place, then slide wireretainer off cover. NOTE: Bulb cover will fall if not held in placewhile removing wire retainer.2. Remove bulb cover and light bulb.3. Replace with a 40-watt appli-ance bulb.4. Replace bulb cover and se-cure with wire retainer.5. Reconnect power to range. Reset clock.Oven LightCAUTION• Disconnect power to range before replacing light bulb.• Use a dry potholder to prevent possible harm to handswhen replacing bulb.• Be sure bulb is cool before touching bulb.• Do not touch hot bulb with a damp cloth as this may causethe bulb to break.BULB COVERWIRERETAINER