Jenn-Air JDR8895BAS13 Installation Instructions Manual

Also see for JDR8895BAB13: Installation & use manual Installation instructions Parts list Installation Instructions and Use & Care Guide

Contents

2= Attach terminal lugs to line 1 (black), bare (green) ground, andline 2 (red) wires. Loosen (do not remove) the set screw on thefront of the terminal lug and insert exposed wire end throughbottom of terminal lugs. Securely tighten set screw to XX Ibs-in. torque. See Bare Wire Torque Specifications chart.C DA. Terminal lugB. Set screwC. Line 1 (black) wireD. Bare (green) ground wireE. Line 2 (red) wireBare Wire Torque SpecificationsAttaching terminal lugs to the terminal block - 20 Ibs-in. (2.3 N-m)Wire Awg Torque8 gauge copper 25 Ibs-in. (2.8 N-m)6 gauge aluminum 35 Ibs-in. (4.0 N-m)3. Use 3/8"nut driver to connect the bare (green) ground wire tothe center terminal block post with one of the 10-32 hex nuts.iS_LDCA. 10-32 hex nutB. Line 1 (black)C. Ground-link screwD. Bare (green) ground wireE. Line 2 (red)F Terminal lug4. Connect line 1 (black) and line 2 (red) wires to the outerterminal block posts with 10-32 hex nuts.5. Securely tighten hex nuts.6. Replace terminal block access cover.v _,,_,,s S %,,,Olq/"@C OFSExplosion HazardUse a new CSA International approved gas supply line.Install a shut=off valve.Securely tighten all gas connections.if connected to LP, have a qualified person make suregas pressure does not exceed 14" (36 cm) watercolumn.Examples of a qualified person include:licensed heating personnel,authorized gas company personnel, andauthorized service personnel.Failure to do so can result in death, explosion, or fire.Typical flexible connection1. Apply pipe-joint compound made for use with LP gas to thesmaller thread ends of the flexible connector adapters (see Band G in the following illustration).2. Attach one adapter to the gas pressure regulator and theother adapter to the gas shutoff valve. Tighten both adapters.3. Use a _SAe"combination wrench and an adjustable wrench toattach the flexible connector to the adapters. Check thatconnector is not kinked.A. Gas pressure regulatorB. Use pipe-joint compound.C. Adapter (must have V2"malepipe thread)D. Flexible connectorE. Manual gas shutoff valveF V2" or 3/4"gas pipeG. Use pipe-joint compound.H. Adapter15