Jenn-Air JES9750CAB00 Installation Instructions Manual

Also see for JES9750CAB01: Use & care guide Installation Instructions and Use & Care Guide

Contents

8. Floor Ventingg=Check that the anti-tip bracket is installed and that electricalcords are not kinked. Use a flashlight to look underneath thebottom of the range.• Look for the anti-tip bracket securely attached to floor orwall.• Slide range back so rear range foot is under anti-tipbracket.Level the range.a.) Place rack in oven.b.) Place level on rack and check levelness of the range, firstside to side; then front to back.c.) If range is not level, pull range forward until rear levelingleg is removed from the anti-tip bracket.d.) Use a wrench or pliers to adjust leveling legs up or downuntil range is level.e.) Push range back into position.f.) Check that rear leveling leg is engaged in anti-tip bracket.NOTE: Range must be level for satisfactory baking performance.10. Depending on your installation, connect the flexible vent fromthe blower motor inlet to the range using a vent clamp.Wall VentingTop ViewBi ¸_ .... !C,A. RangeB. Wall venting outletC. Vent clampTop ViewAA. RangeB. Floor venting outletC. Vent clampSide Venting (left side venting shown)Connect flexible vent duct to range and connect vent systemto blower motor outlet.Top ViewAECA. Flexible vent duct to rangeB. Vent clampC. Range11. Replace access panel./BD. Vent systemE. Side venting outlet20