Jenn-Air JES9750CAB00 Installation Instructions Manual

Also see for JES9750CAB01: Use & care guide Installation Instructions and Use & Care Guide

Contents

12. Insert downdraft vent filter and place vent cover overopening.BA. FilterB. Grate13. Reconnect power.1. Check that all parts are now installed. If there is an extra part,go back through the steps to see which step was skipped.2. Check that you have all of your tools.3. Dispose of/recycle all packaging materials.4. Check that the range is level. See "Connect Range toDowndraft System."5. Use a mild solution of liquid household cleaner and warmwater to remove waxy residue caused by shipping material.Dry thoroughly with a soft cloth. For more information, readthe "Range Care" section of the Use and Care Guide.6. Read "Range Use" in the range Use and Care Guide.7. Turn on surface burners and oven. See the Use and CareGuide for specific instruction on range operation.If range does not operate, check the following:• Household fuse is intact and tight; or circuit breaker has nottripped.• Range is plugged into an outlet.• Electrical supply is connected.• See "Troubleshooting" in the Use and Care Guide.When the range has been on for 5 minutes, check for heat. Ifrange is cold, turn off the range and contact a qualifiedtechnician.8. Use the Flow Tester Card provided with your range to checkthe airflow (see card for step-by-step instructions).FLOW TESTER::;.j2£;?-?/:??72::o::......,=,,.................. _.......If there is not sufficient airflow, review the "VentingRequirements" and "Venting Methods" sections.If you need Assistance or Service:Please reference the "Assistance or Service" section of the Useand Care Guide or contact the dealer from whom you purchasedyour range.Tip Over HazardA chi(d or adult can tip the range and be killed.Connect anti=tip bracket to rear range foot.Reconnect the anti=tip bracket, if the range is moved.Failure to follow these instructions can result in deathor serious burns to children and adults.When moving range, slide range onto cardboard or hardboard toavoid damaging the floor covering.If removing the range is necessary for cleaning or maintenance:For power supply cord-connected ranges:1. Disconnect range from downdraft vent system.2. Slide range forward.3. Unplug the power supply cord.4. Complete cleaning or maintenance.5. Plug in power supply cord6. Check that anti-tip bracket is installed, remove access paneland use a flashlight to look underneath the bottom of therange:• Look for the anti-tip bracket securely attached to floor orwall.• Slide range back so rear range foot is under anti-tipbracket.7. Check that range is level.8. Reconnect range to downdraft vent system.21