103. Insert the ³⁄₈" socket and extension into the hole and use theratchet handle to loosen the nut half of a rotation. Repeat thisprocess for each of the 4 nuts.4. With the nuts loosened, the blower exhaust scroll can beeasily rotated downward.5. Retighten each nut with the ³⁄₈" socket, extension and ratchet.6. Reinstall the 4 plastic plugs.To rotate blower motor:NOTE: The “Top” label location on the blower motor is at the9 o’clock position.1. Using a ratchet with a ³⁄₈" socket and supporting the motorwith one hand, remove the 4 machine nuts that attach theblower motor to the exhaust scroll.2. Remove the blower motor and wheel assembly from the weldstuds.3. When the motor mounting plate clears the threaded weldstuds, rotate the assembly clockwise 90° and reinstall thefour #10-32 machine nuts.4. Verify the “Top” label is positioned as shown.5. Follow steps 5 - 10 in the “Install Cooktop” section.Make Gas Connection1. Apply pipe-joint compound made for use with Natural and LPgas to the smaller thread ends of the flexible connectoradapters (see C and G in the following illustration).2. Attach one adapter to the gas pressure regulator and theother adapter to the gas shutoff valve. Tighten both adapters.3. Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers toattach the flexible connector to the adapters. Check thatconnector is not kinked.A. Top labelB. Blower motorC. Motor mounting plateD. Weld stud locationE. Blower wheelBADC EA. Top labelAWARNINGExplosion HazardUse a new CSA International approved gas supply line.Install a shut-off valve.Securely tighten all gas connections.If connected to LP, have a qualified person make suregas pressure does not exceed 14" (36 cm) watercolumn.Examples of a qualified person include:licensed heating personnel,authorized gas company personnel, andauthorized service personnel.Failure to do so can result in death, explosion, or fire.