Jenn-Air JXT6030ADR Installation & Use Manual

Also see for 30" WALL-MOUNT CANOPY RANGE HOOD: Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide

Jenn-Air JXT6030ADR Installation & Use Manual Manual pdf 8 page image

8Non-Vented (recirculating) Installations1. Connect the deflector to the vent cover bracket using 4 - 3.5x 9.5 sheet metal screws provided.Complete Preparation1. Determine and make all necessary cuts in the wall for the ventsystem. Install the vent system before installing the hood. See“Venting Requirements” section.2. Determine the required height for the home power supplycable and drill a 1¼" (3.2 cm) hole at this location.3. Run wire through the home power supply cable according tothe National Electrical Code or CSA Standards and localcodes and ordinances. There must be enough ½" conduitand wires from the fused disconnect (or circuit breaker) boxto make the connection in the hood’s electrical terminal box.NOTE: Do not reconnect power until installation is complete.4. Use caulk to seal all openings.Install Range Hood1. Using 2 or more people, hang range hood on 2 mountinghooks through the rectangular cutouts on back of hood.2. Level the hood with leveling screws in mounting hooks orrectangular cutouts, using a level across bottom of hood.3. Secure hood with 4 screws through remaining 4 holes inhood.Connect Vent System1. Install transition on top of hood (if removed for shipping) with4 - 3.5 x 9.5 mm sheet metal screws.A. Vent cover bracketB. 3.5 x 9.5 mm sheet metal screwsABA. Mounting hooksB. 5 x 35 mm mounting screwsC. Leveling screwsD. Centerline on wallA. Vent transitionB. 3.5 x 9.5 mm screwWARNINGExcessive Weight HazardUse two or more people to move and installrange hood.Failure to do so can result in back or other injury.ABBCDABB