Complete Connection1. Open the manual shutoff valve in the gas supply line. Thevalve is open when the handle is parallel to the gas pipe.A. Closed valveB. Open valve2. Test all connections by brushing on an approvednoncorrosive leak-detection solution. If bubbles appear, aleak is indicated. Correct any leak found.3. Remove cooktop burner caps, burner bases and grates fromparts package. Place burner bases on cooktop, burner capson burner bases and place grates over burners and caps.Electrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.NOTE: Range must be level for satisfactory baking performance.1. Place rack in oven.2. Place level on rack and check levelness of the range, firstside to side; then front to back.3. If range is not level, adjust the leveling rods. Turn levelingrods located behind the kick plate to level range and to raiseor lower range to the desired countertop height.NOTE: All roller feet must be off the floor upon final installation.BABA. Front leveling rodB. Rear leveling rod4. Plug into a grounded 3 prong outlet.5. Turn on power supply. For further information, please refer tothe user instructions located in the Use and Care Guide.1. Turn all 4 leveling rods 1 full turn to raise the range andprovide enough clearance for the rear leveling leg to slide intothe anti-tip bracket.2. Move range into its final location making sure rear leveling legslides into anti-tip bracket.NOTE: If installing the range in a mobile home, you must securethe range to the floor. Any method of securing the range isadequate as long as it conforms to the standards in the "LocationRequirements" section.The griddle is factory installed.1. Place drip tray in the well at the front of the griddle. Slide traytoward the back until it stops.AA. Griddle drip trayB. Griddle2. Clean griddle before using. Refer to the Use and Care Guide.10