Jenn-Air PRO-STYLE JGRP430WP01 Installation Instructions Manual

Also see for PRO-STYLE JGRP430WP01: Use & care guide

Contents

Replace Oven Bake Burner Cover1. Align rear shoulder screw mounting holes (keyholes) on theoven bake burner cover with shoulder screws in the bottomof the oven.2,A. Shoulder screw mounting holes (keyholes)B. Shoulder screwsDrop cover and slide to left or right to slide shoulder screwsinto narrow ends of keyholes and lock into place.AA. Bake burner coverTo Convert Surface Burners1,2.3.If the burner grates are installed, remove them.Remove burner cap.Remove the burner base.Large Dual Burner4,, _''_''A A. Burner capB. Burner base4. Apply masking tape to the end of a 7 mm nut driver to helphold the gas orifice spud in the nut driver while changing it.Insert nut driver into the gas opening and press down ontothe gas orifice spud and remove by turning the gas orificespud counterclockwise and lifting out. Set gas orifice spudaside.5. Replace with correct LP gas orifice spud. See the "LP GasOrifice Spud/Hood Chart."Use the following chart to find the exact orifice spudplacement.Fully insert choke into bottom of medium burner base. Chokeshould snap into place.LP Gas Orifice Spud/Hood ChartBurner Color Size Burner StyleRating3,000 BTU Blue 0.55 mm Small burners11,000 BTU Yellow 0.97 mm Medium burners14,000 BTU Red/ 1.05 mmGreen 0.35 mmLarge burner - mainLarge burner - simmer_L_14,500 BTU Black 1.18 mm Grill burnerBurner orifice spudAA. Size stamp or color6. Place Natural gas orifice in plastic parts bag for future useand keep with package containing literature.7. Replace the burner base.8. Replace burner cap.9. Repeat steps 2 through 8 for the remaining burners.10. Unplug range or disconnect power.11. Remove the control knobs........:_L...................AC=----_'_! /__,, '"Bl ...... __AMedium BurnerA. Burner capB. Burner baseC. Choke (for use with mediumburner, LP gas only)Small BurnerA. Burner capB. Burner base19