Jenn-Air W10379136B Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation instructions

Contents

Jenn-Air W10379136B Installation Manual Manual pdf 23 page image

23■ Use hex key to raise or lower the adjustment pins whichallows the door panel to swivel.3. Predrill an ¹⁄₈" deep pilot hole, using an ¹⁄₈" drill bit, into thedoor panel through the open holes in both the bottom andtop hinges.4. Using slotted hex-head screws (provided with refrigerator),attach the top and bottom hinges to the door panels. Fullytighten all door panel screws.5. Using slotted hex-head screws (provided with refrigerator) foreach side, attach the door panels to the hinge-side doortrims.6. Using Phillips head flat screws (provided with refrigerator),install the handle side door trim.7. Completely tighten the screws attaching the mountingbrackets, located at the bottom of the doors, to the overlaypanels.8. Reinstall the top door trim and hinge cover.9. Snap the adjustment pin cover (provided with refrigerator)into place.Install Handles(Panel Kit Models Only)IMPORTANT: Install the handles after the door panels have beeninstalled. Follow the instructions specific to your door paneldesign.Tools Needed: ³⁄₃₂" hex keyDoor Panels—Custom Wood, Stainless Steel andOiled Bronze Designs1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Fasten the handle mounting studs to the door panels.3. Install the handles to the handle mounting studs and tightenthe setscrews.Door Panels—Floating Glass DesignIMPORTANT: To align the handle correctly on the door, theplastic handle spacer and the setscrews on the door handle mustbe in the positions designated in the chart.1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Insert the circular post on the back of the handle spacers intothe holes in the door panels.3. Depending on the compartment, rotate the plastic spacer sothat the curved handle mounting posts are either at the top orbottom. See the following chart.4. Slide the screw into the handle mounting stud. Insert thescrew assembly into the center hole of the plastic spacer andfasten it to the door panel.5. Install the handles to the handle mounting studs so that thesetscrews are on the designated side and tighten thesetscrews.A. Door panelB. Mounting bracketC. Adjustment pinsA. Top hingeB. Mounting bracketC. Holes for screwsD. Adjustment pinsABCBADCA. Plastic handle spacerB. Straight handle mountingpostsC. Curved handle mountingpostsD. Circular postFreezerLeft-Hand Door RefrigeratorRight-Hand DoorCurvedMounting PostBottom TopSetscrews Right LeftA B DCB C