Jensen MP6211 Instruction Manual

Also see for MP6211 - Radio / CD: Quick start guide

Jensen MP6211 Instruction Manual Manual pdf 8 page image

MP62114INSTALLATIONThis unit is designed for installation in cars, trucks and vans with an existing radio opening. Inmany cases, a special installation kit will be required to mount the radio to the dashboard.These kits are available at electronics supply stores and car stereo specialty shops. Alwayscheck the kit application before purchasing to make sure the kit works with your vehicle. If youhave trouble locating a kit or need installation assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pmEST on Saturday.Universal Installation Using Mounting Sleeve1. Remove the detachable front panel, if it is attached to the chassis, by pushing the“Release” button.2. Slide the mounting sleeve off of the chassis if it has not already been removed. If it islocked into position, use the removal keys (supplied) to disengage it. The removal keysare depicted on page 5.3. Check the dashboard opening size by sliding the mounting sleeve into it. If the opening isnot large enough, carefully cut or file as necessary until the sleeve easily slides into theopening. Do not force the sleeve into the opening or cause it to bend or bow. Check thatthere will be sufficient space behind the dashboard for the radio chassis.4. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve.With the sleeve fully inserted into the dashboard opening, bend as many of the tabsoutward as necessary to firmly secure the sleeve to the dashboard.5. Place the radio in front of the dashboard opening so the wiring can be brought through themounting sleeve.6. Follow the wiring diagram carefully and make certain all connections are secure andinsulated with crimp connectors or electrical tape to ensure proper operation.7. After completing the wiring connections, attach the front panel and turn the unit on toconfirm operation (vehicle ignition switch must be on). If the unit does not operate,recheck all wiring until the problem is corrected. Once proper operation is achieved, turnthe ignition switch off and proceed with final mounting of the chassis.8. Carefully slide the radio into the mounting sleeve making sure it is right-side-up until it isfully seated and the spring clips lock it into place.9. Attach one end of the perforated support strap (supplied) to the screw stud on the rear ofthe chassis using the hex nut provided. Fasten the other end of the perforated strap to asecure part of the dashboard either above or below the radio using the screw and hex nutprovided. Bend the strap, as necessary, to position it. CAUTION: The rear of the radiomust be supported with the strap to prevent damage to the dashboard from the weight ofthe radio or improper operation due to vibration.10. Re-attach the front panel to the chassis and test radio operation by referring to theoperating instructions for the unit.NOTE: For proper operation of the CD player, the chassis must be mounted within 20° ofhorizontal. Make sure the unit is mounted within this limitation.