Jet GH-1340W Owner's Manual
Also see for GH-1340W: Parts list
                        | |
11Coolant Preparation CAUTIONFollow coolant manufacturer'srecommendations for use, care, anddisposal.1. Remove rear access cover on tailstockend. Make sure coolant tank has notshifted during transport and is locatedproperly under the recovery chute (Fig. 9).2. Pour three gallons of coolant mix into drippan.3. After machine has been connected topower, turn on coolant pump and check tosee coolant is cycling properly.4. Fasten coolant door to stand.Electrical Connections WARNINGAll electrical connections must becompleted by a qualified electrician!Failure to comply may cause serious injuryand / or damage to the machinery andproperty!The GH-1340W-1 & GH-1440W-1 Gear HeadLathes are rated at 3HP, 1Ph, 230V only.Confirm power available at the lathe's locationis the same rating as the lathe.The GH-1340W-3 & GH-1440W-3 Gear HeadLathes are rated at 3HP, 3Ph, 230V/460Vprewired 230V. Confirm power available atthe lathe's location is the same rating as thelathe.Lathe Power Source Junction Box:Remove the cover. Run the main powerthrough the strain relief bushing and attach theground, followed by power leads. Replace thecover.Main Power Switch: Located on thebackside of the machine. Turns the power tothe machine on and off. |
Related manuals for Jet GH-1340W
manualsdatabase
Your AI-powered manual search engine