Jet GH-1340W Owner's Manual

Also see for GH-1340W: Parts list

Contents

Jet GH-1340W Owner's Manual Manual pdf 17 page image

1715. Tool Post Clamping Lever (J, Fig. 14) -located on top of the tool post. Rotatecounter-clockwise to loosen and clockwiseto tighten.16. Tailstock Quill Clamping Lever(A, Fig. 15) - located on the tailstock. Liftup to lock the spindle. Push down tounlock.17. Tailstock Clamping Lever (B, Fig. 15) -located on the tailstock. Lift up lever tolock. Push down lever to unlock.18. Tailstock Quill Traverse Handwheel(C, Fig. 15) - located on the tailstock.Rotate clockwise to advance the quill.Rotate counter-clockwise to retract thequill.19. Tailstock Off-Set Adjustment(D, Fig. 15) - two hex socket cap screwslocated on the tailstock base are used tooff-set the tailstock for cutting tapers.Loosening one screw while tightening theother off sets the tailstock.20. Foot Brake (A, Fig. 16) - located betweenstand pedestals. Depress to stop all lathefunctions.21. Micro Carriage Stop (B, Fig. 16) - locatedon the lathe bed. Loosen two hex socketcap screws underneath body and slidealong bed to desired position. Tightenscrews to hold in place.22. Main Power Switch (not shown) - locatedon the electrical box door on the rear ofthe lathe. Turns main power to the latheon and off.Break-In ProcedureDuring manufacture and testing, this lathe hasbeen operated in the low R.P.M. range forthree hours.To allow time for the gears and bearings tobreak-in and run smoothly, do not run thelathe above 650 R.P.M. for the first six hoursof operation and use.