Jet J-7040 Operating Instructions And Parts Manual

Also see for J-7020: Operating instructions and parts manual

17Figure 21: Model J-7020 cut-off saw wiring diagram4. Close the blade cover and secure with four knobs.ElectricalObserve the following when connecting to the powersource. (The cut-off saw wiring diagrams are providedin Figures 17 and 18.)WARNING: JET RECOMMENDS THAT ANY WIRINGINVOLVING HARD WIRING OF THE SAW TO ABRANCH, OR ANY CHANGE OF VOLTAGE SUPPLIEDTO THE MOTOR BE PERFORMED BY A LICENSEDELECTRICIAN.1. Make sure the saw is disconnected from the powersource, or that the fuses have been removed or break-ers tripped in the circuit in which the saw will beconnected. Make sure you put a warning placardon the fuse or circuit breaker to prevent accidentalelectrical shock.2. If you are installing the motor power cord into a re-ceptacle, make sure to use the appropriate plug.3. If you are using hard-wired connections to a junc-tion box, connect the wires in the box, and closethe box.4. Install the fuses or reset the breaker.5. The saw is now ready for service.Figure 22: Connection diagram for 1ph motor1L2115 Volt3 2 4L11L2220 Volt2 3 4L1