Jet JBTS-10MJS Operating Instructions And Parts Manual

Also see for JBTS-10MJS: Specifications

Jet JBTS-10MJS Operating Instructions And Parts Manual Manual pdf 17 page image

17AdjustmentsSetting up the StandReferring to Figure 16:1. Release the stand lock hook (D) by sliding itaway from the stop screw.2. Raise the handle cover (A) first, then pull thelocking handle (B) out and hold.3. Step on the pedal (C) and pull the standupward until it is fully unfolded.4. Release the locking handle (B) to lock thestand into position. Lower the cover (A).Note: Make sure the stand is locked securely.5. Place the stand on a level surface and adjustthe left stand pad (Z, Fig. 5) so that all legs arecontacting the floor and are at a similar angle tothe floor.Note: Make sure the table saw is lockedsecurely in position. Adjust the stand pad tomake sure the table saw is totally stable.Folding the Stand1. Raise the handle cover (A, Fig. 16) first andpull the locking handle (B, Fig. 16) out.2. Push slowly downward on the stand (A, B, Fig. 17).3. Release the locking handle (B, Fig. 16).4. Rotate the stand hook (D, Fig. 16) onto thestop screw to secure the stand legs into thecollapsed position.5. Secure the side extension table (H, Fig. 16) bypushing the cam locking lever (F, Fig. 16)downward.Note: For convenient storage, there are twostand up supports (G, Fig. 16) on the right sideof the table saw for supporting the table sawwhen not in use (C, Fig. 17).Adjusting the Table InsertThe table insert (A, Fig. 18) is already installed onyour table saw. Verify that the table insert is flush withthe table top surface on all four corners of the insert.To avoid serious injury, thetable insert must be level with the table.If the table insert is not flush with the table, adjustthe four hex screws (B, Fig. 18) with a 4 mm hexwrench until it is flush with the table.To raise the insert, turn the hex screws (B) counter-Figure 16Figure 17Figure 18clockwise. To lower the insert, turn the hex screwsclockwise.