Jet JBTS-10MJS Operating Instructions And Parts Manual

Also see for JBTS-10MJS: Specifications

Jet JBTS-10MJS Operating Instructions And Parts Manual Manual pdf 7 page image

7SpecificationsStock Number .......................................................................................................................... 707000Motor ................................................................................................. 120VAC, 1PH, 60Hz, 15A, 4.4HPBlade Speed - no load (RPM) ........................................................................................................ 4000Saw Blade Diameter (in.)................................................................................................................... 10Arbor Diameter (in.) ......................................................................................................................... 5/8Blade Tilt (deg.) ...........................................................................................................................45 leftRip Capacity (in.) .............................................................................................................................. 25Maximum Cutting Depth at 90º (in.)................................................................................................ 3-1/8Maximum Cutting Depth at 45° (in.) ............................................................................................... 2-1/2Dado Capacity (in.) ................................................................................................................. 13/16 x 6Table Height, with Stand (in.)............................................................................................................. 35Main Table Size (in.) .......................................................................................................... 24 W x 21 DTable Size with Side and Rear Extension Wings (in.) ..................................................... 30-1/4 W x 21 DTable Size with Both Wings Fully Extended (in.) ....................................................... 42-3/8 W x 35-3/4 DDust Port Diameter (in.)................................................................................................................. 2-1/2Gross Weight (lbs.) ......................................................................................................................... 105Net Weight (lbs.) ............................................................................................................................... 91Definitions and TerminologyArbor: Metal shaft that connects the drivemechanism to the blade.Bevel Edge Cut: Tilt of the saw arbor and bladebetween 0° and 45° to perform an angled cuttingoperation.Blade Guard: Mechanism mounted over the sawblade to prevent accidental contact with the cuttingedge.Crosscut: Sawing operation in which the mitergauge is used to cut across the grain of theworkpiece.Dado Blade: Blade(s) used for cutting grooves andrabbets.Dado Cut: Flat bottomed groove in the face of theworkpiece made with a dado blade.Featherboard: Device used to keep a boardagainst the rip fence or table that allows theoperator to keep hands away from the saw blade.Kerf: The resulting cut or gap made by a sawblade.Kickback: An event in which the workpiece is liftedup and thrown back toward an operator, causedwhen a work piece binds on the saw blade orbetween the saw blade and rip fence (or other fixedobject). To minimize or prevent injury fromkickbacks, see the Operating Instructions section.Miter Gauge: A component that controls theworkpiece movement while performing a crosscutof various angles.Non-Through Cut: A sawing operation thatrequires the lowering of the splitter and removal ofthe blade guard and kick-back pawls, resulting in acut that does not protrude through the top of theworkpiece (includes Dado and rabbet cuts).The blade guard and kick-back pawls must be re-installed and splitter raised after performing a non-through cut to avoid accidental contact with thesaw blade during operation.Parallel: Position of the rip fence equal in distanceat every point to the side face of the saw blade.Perpendicular: 90° (right angle) intersection orposition of the vertical and horizontal planes suchas the position of the saw blade (vertical) to thetable surface (horizontal).Push Board/Push Stick: An instrument used tosafely push the workpiece through the cuttingoperation.Rabbet: A cutting operation that creates anL-shaped channel along the edge of the board.Rip Cut: A cut made along the grain of theworkpiece.Splitter: Metal plate to which the blade guard isattached that maintains the kerf opening in theworkpiece when performing a cutting operation.Standard Kerf: 1/8" gap made with a standardblade.Straightedge: A tool used to check that a surfaceis flat or parallel.Through Sawing: A sawing operation in which theworkpiece thickness is completely sawn through.Proper blade height usually allows a 1/8" of the topof the blade to extend above the wood stock.