Jet JJ-8CS Owner's Manual

Also see for JJ-8CS: Operating instructions and parts manual

Contents

13Installing Access Cover1. Install access cover by placing bottom of panelinto access in stand and fastening by turninglatch (Fig. 17).If the access door latch needs adjustment:1. Remove the access door from the stand.2. Loosen the hex lock nut (A, Fig. 17). Rotatethe latch a quarter turn clockwise to tighten andcounterclockwise to loosen.3. Tighten the lock nut (A, Fig. 17).4. Re-install the access door.Installing Dust Chute1. Attach the dust chute (Fig. 18) to the standwith four screws and four flat washers, throughthe pre-tapped holes in the stand.Electrical Connections WARNINGAll electrical connections must be done bya qualified electrician! Failure to complymay result in serious injury!Remove the cover of the electrical box (A, Fig. 19)and mount the box to the right side of the standusing the two screws provided. Insert the motorleads through the hole in the stand as shown, andinsert a grommet (B, Fig. 19).Consult the wiring diagram on page 28 when wiring.The JJ-8CS jointer is rated at 230V, single phaseonly. Confirm that the power at the source is com-patible with the jointer before inserting plug into theoutlet. The jointer is designed to be used with aplug and outlet as in Fig. 20.Important: Make certain the receptacle in ques-tion is properly grounded. If you are not sure,have a registered electrician check the recep-tacle.Fig. 17Fig. 18Fig. 19Fig. 20