8Installing Bed to Stand1. Use an assistant or hoist mechanism to placebed assembly on top of stand. Be sure identi-fication label on the bed faces the same direc-tion as the label on the stand (Fig. 1).2. Line up two holes in top of stand with holes inbed assembly by viewing through access doorin stand.3. Attach bed assembly to stand with two 3/8"lock bolts and lock washers (Fig. 2). Handtighten only at this time.4. Line up third hole in stand with hole in bed as-sembly by viewing through dust chute.5. Install third 3/8" lock bolt and lock washerthrough dust chute to secure bed to stand.6. Tighten all three mounting bolts with 14mmwrench.Installing Handwheels1. Remove protective tape from shaft, and removescrew and washer.2. Press handwheel (A, Fig. 3) onto shaft, align-ing the key way with the key. If necessary, usea hammer with a block of wood to tap thehandwheel completely onto the shaft.3. Re-install screw and washer (B, Fig. 3).4. Mount handle (C, Fig. 3) onto handwheel.Fig. 1Fig. 2Fig. 3