Shipping Container Contents1111MillFlat Way Cover (rear)Accordion Way Cover (front)Tool Box:1 Hex Wrench Set (1.5 - 10mm)1 19mm Combination Wrench1 #2 Cross Point Screw Driver1 #2 Flat Blade Screw Driver1 Plastic Oil Can1 Operator's Manual1 Warranty Card1 Eye Bolt,-----.L.~,2~.~ ~-t .. .- '.'.. jETi. ~.".--. ~~--~.",.-'W' -. .Unpacking and Clean-Up.1. Finish removing the sides and top of the crate.Leave the mill bolted to the skid until it is readyto move to its final location.2. Clean all rust protected surfaces with keroseneor a light solvent. Do not use gasoline, paintthinner, or lacquer thinner. These will damagepainted surfaces.J3. Cover all machined surfaces with a film of lightmachine tool oil to inhibit rust.Fig.1Site Preparationit. CautionMill must be supported equally under all fourcomers. Failure to comply may cause thecolumn to twist and put a bind in the bedways.The mill must be placed on an even surface andbolted to the floor. Anchor bolts of sufficient size andlength must be fastened to the floor according to thefootprint of the mill. See Fig. 1.4