Jet JTM-1050EVS Operator's Manual

Contents

Electrical Connectionsit WARNINGA qualified electrician must make all electricalconnections!Failure to comply may cause serious injury!The JTM-1050EVS mill is pre-wired from thefactory. Stock Number 690060 is Pre-wired 230V.Stock Number 690062 is Pre-wired 460V. Thismachine is not dual voltage.Confirm power at the site matches powerrequirements of the mill before connecting to thepower source.The mill must be properly grounded.ControlsA. Spindle Brake (A, Fig. 4) - located on left side ofthe head. Move in either direction to stopspindle once power has been turned off.B. High-Neutral-Low Lever (B, Fig. 5) - located onthe right side of the head. Upper position is highspeed (direct drive). Middle position is neutral.Lower position is low speed (back gear).CautionDo not shift High-Low Gear while motor isrunning. Rotate the spindle by hand to facilitatechanging lever positions.C. Power Feed Transmission EngagementCrank (C, Fig. 5) - located on the right side ofthe head. When lever is in the right-hand sidehole, the power feed worm gear is disengaged.To engage power feed, pull knob out and movelever around to the left-hand side. Release thepin into the hole.Fig.4I. !8~WJI6 Fig.S