Lifting the MillThe method for lifting the mill is with a hook throughthe eye bolt (A, Fig. 2) screwed into the tapped holeon the ram. Steady the mill to prevent it fromspinning.Note: Tighten ram locking bolts (8, Fig. 2) beforelifting.Carefully lift the mill and move to a position over theanchor bolts. Lower the mill over the anchor bolts,check for level, and secure with washers and anchorbolt nuts.Check the mill for level with a machinist's levelplaced on the table. Mill must be level back to frontand side to side. Shim if necessary, but rememberthat the mill must be supported equally at all fourcorners. Check for level before tightening the anchorbolt nuts and after tightening them. Adjust asnecessary.Note: The JTM-1050EVS pictured in figure 2 showsDRO, and POWERFEED optional accessoriesavailable through JET.LubricationCautionDo not shift High-Low Gear while motor isrunning. Rotate the spindle by hand to facilitatechanging lever positions.Spindle Bearings - (A, Fig. 3) fill oil cup once dailywith 1OW-machineoil.Oil Pump - (C, Fig. 2) fill reservoir as needed byremoving cap on top of tank and filling with 10Wmachine oil. Pump oil with release handle once forevery hour of operation. Way surfaces andleadscrews are lubricated in this manner.Knee Leadscrew - (D, Fig. 2) lubricate with #2 tubegrease once weekly.A~/_a iI"~Fig.25 Fig.3