Jet JVM-836 Operator's Manual

Also see for JVM-836: Operating instructions and parts manual Operator's manual

Contents

Jet JVM-836 Operator's Manual Manual pdf 10 page image

K. Longitudinal Movement (J, Fig. 6)handles located on opposite ends of thetable. This controls the X axis.L. Cross Movement (K, Fig. 6) handlelocated directly in front of the machine.This controls the Y axis.M. Knee Handle (L, Fig. 6) this raises thetable up and down.Changing Speeds1. Unscrew two knobs (A, Fig. 4) and removebelt cover.2. Loosen hex nut (A, Fig. 7).3. Take the tension off the belt by movinghandle (B, Fig. 7).4. Use the RPM chart, located on the back ofthe belt cover, to place the belt in thedesired position.5. Place tension on the belt by movinghandle.6. Tighten hex nut.7. Always replace the belt cover!Note: The 3 Ph motor has an additional lowand high-speedsetting(H, Fig.5).Position of RamCAUTION!Care should be taken to lock ram securelyafter setting.Ram can be moved by loosening twohandles (A, Fig. 8), and turning handle (B, Fig.8) to desired position.Note: It is recommended while doing heavymilling work the head should be left as close toface of turret as possible. Maximum rigidity isthen obtained.IK..... -,'Fig.6I'~:'_II.Fig.7BFig.89