Jet JWBS-12OS Operating Instructions And Parts Manual

Contents

Jet JWBS-12OS Operating Instructions And Parts Manual Manual pdf 11 page image

11AdjustmentsUnplug the machine from thepower source before making any repairs oradjustments. Failure to comply may causeserious injury.Tilting the TableReferring to Figure 6:1. Loosen the lock handle.2. Tilt table up to 45 degrees to the right or up to5 degrees to the left. The angle can be read onthe scale mounted to the trunnion.3. Tighten the lock handle.Note: To allow the table to tilt to the left, the tablestop must be adjusted downward (see below).Adjusting 90º Table StopRefer to Figure 6 except where noted otherwise.1. Disconnect machine from power source.2. Loosen the lock handle and tilt the tablebringing it to rest against the table stop.3. Use a square placed on the table and againstthe blade (Figure 7) to see if the table is 90degrees to the blade.4. If an adjustment is necessary, loosen the lockhandle, tilt table from the table stop as shown,and lock in place.5. Loosen the jam nut and turn the table stop leftor right to raise or lower the stop. Tighten thejam nut to hold the table stop in place.6. Unlock the table, tilt back letting it rest againstthe stop and confirm table is 90 degrees withthe blade.Changing BladesBlade teeth are sharp! Use carewhen handling the saw blade. Failure to complymay cause serious injury.Note: The JWBS-12OS Band Saw comesequipped with a 1/4"x82"x20" blade (Part No.709392) factory installed.Referring to Figure 8:1. Disconnect machine from power source.2. Open both wheel covers (D, E).3. Loosen the hex screw (using a 10mm wrench)securing the blade guard (H) and remove.Figure 6Figure 7Figure 8