Jet JWBS-12OS Operating Instructions And Parts Manual

Contents

Jet JWBS-12OS Operating Instructions And Parts Manual Manual pdf 8 page image

8AssemblyRead and understand allassembly instructions before attemptingassembly! Failure to comply may causeserious injury!StandReferring to Figure 1.1. Assemble four legs (E) to the table (F). Secureeach leg with six ea M8x16 carriage bolts (W),M8 flat washers (T), M8 lock washers (S), andM8 hex nuts (Q). Hand-tighten only at this time.2. Assemble the long plates (L) to the legs (E).Secure each plate with 4 ea M8x16 carriagebolts (W), M8 flat washers (T), M8 lockwashers (S), and M8 hex nuts (Q). Hand-tighten only at this time.3. Assemble the short plates (K) in the samemanner as described in step 2.4. Place the stand upright on a level surface.Make sure that all four legs are contacting thesurface.5. Tighten all nuts with a 13mm socket or wrench.Mounting Bandsaw to TableThe saw body is heavy! Usecaution when lifting! Stabilize until firmlyattached to the stand! Failure to comply maycause serious injury!Referring to Figure 2:1. With the aid of a second person, lift the sawbody (A) and place onto the stand top. Be surefront of saw (with JET logo) faces stand front(JET logo).2. Place four M8 flat washers (P) on four M8x35hex cap screws (N) and insert screws throughfour mounting holes in the bandsaw and stand.3. Place M8 flat washers (P) and M8 lock wash-ers (S) on the ends of the screws protrudingthrough the bottom of the stand top. Securewith four M8 hex nuts (Q).4. Tighten all nuts with a 13mm socket or wrench.WWS T QFE LS TQKWSTQLKEFigure 1AStand TopFrontNPPSQ QSPNPFigure 2