Jet JWBS-14OS Operating Instructions And Parts Manual

Also see for JWBS-14OS: Operating instructions and parts manual Operating instructions

Contents

Jet JWBS-14OS Operating Instructions And Parts Manual Manual pdf 8 page image

8Hardware Bag for Stand Assembly01 – Carriage Bolt M8x16 (40)02 – Serrated Hex Flange Nut M8 (40)Hardware Bag for Stand AssemblyTools Required for Assembly1 Accurate Straight Edge (approximately 2 ft)1 Cross-point Screwdriver1 6mm Hex Wrench1 10mm Box Wrench1 13mm Box WrenchNote: Use of sockets and ratchets will speedassembly time but are not required.AssemblyRead and understand allassembly instructions before attemptingassembly! Failure to comply may causeserious injury!The required hardware for all assembly on thismachine is found in the Hardware Bag for StandAssembly and Hardware Bag for Saw Body.Unpacking and Cleanup1. Finish removing all contents from theshipping carton. Do not discard the carton orpacking material until the bandsaw isassembled and is running satisfactorily.2. Inspect the contents for shipping damage.Report damage, if any, to your distributor.3. Compare the contents of the shipping cartonwith the contents list in this manual. Reportshortages, if any, to your distributor.StandReferring to Figure 1.1. Assemble the legs (A) to the table (B). Eachleg requires 6 ea M8 x 16 carriage bolts (C)and 6 ea M8 flange nuts. Hand-tighten onlyat this time.2. Assemble the long plates (E) to the legs (A).Each plate requires 4 ea M8 x 16 carriagebolts (F) and 4 ea M8 flange nuts (G). Hand-tighten only at this time.3. Assemble the short plates (H) to the legs(A). Each plate requires 4 ea M8 x 16carriage bolts (J) and 4 ea M8 flangenuts (K).4. Slip the rubber feet onto the ends of thelegs (L)5. Ensure that the stand is on a level surfaceand all four legs are contacting the surface.6. Tighten all flange nuts with a 13mm socketor wrench.ABCDAEF EGHHJKLFigure 1